lap joint
英 [læp dʒɔɪnt]
美 [læp dʒɔɪnt]
（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝
英英释义
noun
- joint made by overlapping two ends and joining them together
双语例句
- Improvement of Steel Wire Rope Core Belt Lacing Lap Joint Craftwork
钢丝绳芯输送带接头搭接工艺的改进 - When the composites are lapped in the simple way, the lap joint length has no influence on the tensile strength, but it has influence on the breaking elongation and the yield strength.
简单搭接的拉伸强度与搭接长度无关，但对屈服强度和断裂伸长率有影响。 - We can obtain the good appearance and defect-free brass and aluminum alloy lap joint when selecting the appropriate parameters.
焊接时选取合适的工艺参数，可以获得外观形貌良好且无缺陷的异种材料焊接接头。 - The research is carried out with the method of orthogonal test to study the effects of some main parameters such as Poisson ratio, elastic modulus and adherend of thick on the peck value of the Von Mises equivalent stress distributed in adhesively bonded aluminium single lap joint.
运用正交试验法研究了几个主要力学和几何参数如泊松比，弹性模量和被粘物厚对单搭接接头VONMISES等效应力的影响。 - The orthogonal test of numerical modeling on the peck stress distributed in single lap joint
单搭接接头峰值应力数值模拟的正交法分析 - The BEM technique for adhesive-bonded structure proves valid by comparing the stress distribution for double lap joint calculated in this paper with that calculated by finite element method.
对双搭接接头进行了边界元应力分析，并和有限元结果进行了对比，从而证实本文方法的有效性。 - Test shows that this way can exhibit good result to butt joint and lap joint of TIG welding and accurately abstract welding seam out, to the welding seam of large magnitude dogleg angle shows good tracking effect ( dogleg angle< 68 °) and procession speed< 100 ms.
实验表明，系统对TIG焊的对接和搭接焊缝有很好地处理效果，对大幅度折线焊缝也能很好的跟踪（折线角>68°），处理速度>100ms。 - Using boundary element method, the interfacial streeses of adhensive lap joint with either perfect or imperfect interface are studied.
采用边界元法计算分析了具有理想界面和非理想界面的双板条胶合搭接连接的界面应力。 - However, further increasing of RE content would degrade the shear properties of the lap joint.
而当稀土含量进一步增加时，焊点的强度及塑性均下降。 - Finite element analysis on reliability design of adhesively bonded single lap joint
基于有限元方法的单搭接接头可靠性设计